0
Wandering z-offset
(lemmy.world)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 26 Jun 2023
0 points (NaN% liked)
3DPrinting
15525 readers
91 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: !functionalprint@kbin.social or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 1 year ago
MODERATORS
I still have this problem. The right side of the x axis is loose on the upright for me. Adding a dual z-axis didn’t help much, it still sacks sometimes. Next step is to add a cr-touch or completely rebuild. I’d also like to hear some other ideas for permanent fixes
I just checked the right side of gantry arm. I can move it a little if I push kind of hard but there's no "play" in it. I don't think I could tighten that down any more without stressing the motor. I wish I had some reliable way to measure what's actually moving but the only movement I can detect is the z-offset drift.
@prismo I just did some more checks. If I adjust the z-steps to paper height I can put it out of alignment by pushing the right side of the gantry arm up or down. There obviously isn't perfect synchronization between the left side (where the drive screw is) and the right side (where it's just pulled along by the rest of the gantry).
I'm gonna play around with the eccentric nut and some grease to see if I can get it consistent and report back.