this post was submitted on 29 Jan 2024
51 points (94.7% liked)
Linux
48182 readers
1334 users here now
From Wikipedia, the free encyclopedia
Linux is a family of open source Unix-like operating systems based on the Linux kernel, an operating system kernel first released on September 17, 1991 by Linus Torvalds. Linux is typically packaged in a Linux distribution (or distro for short).
Distributions include the Linux kernel and supporting system software and libraries, many of which are provided by the GNU Project. Many Linux distributions use the word "Linux" in their name, but the Free Software Foundation uses the name GNU/Linux to emphasize the importance of GNU software, causing some controversy.
Rules
- Posts must be relevant to operating systems running the Linux kernel. GNU/Linux or otherwise.
- No misinformation
- No NSFW content
- No hate speech, bigotry, etc
Related Communities
Community icon by Alpár-Etele Méder, licensed under CC BY 3.0
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
We'll dunno much but wouldn't the UUID of the drive partition change?
I don't believe it does, if It does though I can report back
If you resize the partition? No, the UUID gets allocated when the partition is created and stays the same for the lifetime of the partition. It only changes if you explicitly change it manually. Which is something that's only needed very rarely.
For example I had to do it when I migrated my root disk to a larger SSD by
cat-ing the entire disk to the new one and I wanted to keep both connected for a while (so I can boot into the old one in case anything went wrong). I had to change the UUID of the partition on the new disk but I still ran into some obscure grub issues and had to boot a system rescue live stick into the new disk to update grub properly. Overall it's not a very good idea, in the future I think I'll stick torsync -avxroot into the new partition.Wait you can cat an entire device to another like that? I’ve always been told to use dd
You can, it will copy until it runs out of source or runs out of destination so it's very simple to use for stuff like this. Performance also tends to be very good because it chooses some good defaults for block size and so on, unlike dd where you have to choose by hand.
dd also has some issues that you have to be aware of such as the fact it will always fill full blocks by default. For example if you choose 1M blocks and your source is 1.5M it will write 2M. It's not a problem in a scenario like I described where the new disk is larger and empty and that extra 0.5M will go unnoticed, but if you had some other partition past the 1.5M mark it may potentially mess it up. You have to use a flag to make it write exactly what it reads ("fullblock" I think – yeah that's intuitive; unless they changed it and now it's reversed by default? I don't even know).
So yeah overall dd is more trouble than it's worth unless you're prepared and need to control the copy super-exactly.
You can even use
cpof I recall correctly,ddallows to tune some parameters but it's not strictly necessary.In my case it actually changed after i resized it. It was unexpected and broke my system. After i adjusted the UUID in the boot config it worked again.
That's really unusual and yeah I can see how that would surprise you. What tool did you use to resize it?
Thinking about what i did (already a few weeks ago) i think it makes sense now. A lot of sources suggested it would be easiest to delete the partition and simply create a new bigger one at the same start blocks. And then resize the FS. Then it actually makes sense why i ended up with another UUID.
Ahhhh I see now, that explains it. 😃 Yeah it's not a bad method if you need to resize a partition in place, but you need to be super careful to restore all the partition parameters like sector size etc. exactly the same. And ofc to restore the previous UUID from inside the partition editor (fdisk or gpt) or with
tune2fs -U.For future reference it's best to use parted instead, which will take care of everything for you. Best to boot into a GParted live stick for any operations on essential partitions, not to do it on the live system. Same thing for copying partitions, use a Clonezilla live stick. With Ventoy you can make a USB stick with several such tools on it, you just install Ventoy and then drop ISO files on the stick.
Jep. I really would not recommend doing it that way, but when i saw that method i wanted to try it out. Had a full disc backup done before that anyway.