DarwinFPV BabyApe is $80 and flies better than anything you’ve built 4 years ago due to improvements in Betaflight. Sure, if you want O3 you need to pay more.
elrs_failsafe
joined 1 year ago
Open the door sensor, locate the reed switch, remove it and connect wires to its PCB pads. Although it should be pretty straightforward to measure the minimum distance required between the magnet and the sensor and install the magnet just a bit closer, so that any cracking of the door opens the switch. If you use a weaker magnet, the sensor will be more sensitive to the distance, so you will be able to detect smaller gaps.
Side note: if the door doesn't close when there's a small gap, the fridge might not be level or your door auto-closing mechanism might be worn out.
Did the same with Trianglelab Dragon. Damaged the heatbreak as well when disassembling the hotend. Now I own a 1.8Nm torque wrench..
You probably can! At least if your FCs are at least F4/F7 - F3 series microcontrollers are no longer supported. But the way Betaflight 'upgrades' work you'll need to reconfigure the FC after the upgrade. And using the CLI dump made with an older firmware version isn't supported - some options go away or get renamed, PID tuning options in particular should not be blindly copied between versions.
O3 is the best quality digital video system (made by DJI). The air unit (camera+digital vtx) is $230, and the goggles are $500. It can also record up to 4K at 120 FPS (in-goggle max quality is 1080p at 100FPS). Analog is definitely way cheaper (at least the vtx side), but I think most people who could afford digital have switched over the last couple of years.