34
Can anyone recommend an actually good 3d printer?
(hexbear.net)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 13 Jul 2024
34 points (100.0% liked)
askchapo
22745 readers
261 users here now
Ask Hexbear is the place to ask and answer ~~thought-provoking~~ questions.
Rules:
-
Posts must ask a question.
-
If the question asked is serious, answer seriously.
-
Questions where you want to learn more about socialism are allowed, but questions in bad faith are not.
-
Try !feedback@hexbear.net if you're having questions about regarding moderation, site policy, the site itself, development, volunteering or the mod team.
founded 4 years ago
MODERATORS
I use 3d printers to make parts on a weekly basis.
The fdm (squirting) ones that are “set and go” start around $2000.
Most of that is having a controlled environment for the squirt to transition in and having “profiles” appropriate for doing more than making bowsette statues.
It’s hard to use the information in the diy community to make functional parts because they’re all making bowsette statues.
The exception is guns. The gun people have extensive information that will allow anyone to produce a functional (?) firearm (?) using a $99 printer and the cheapest pla on Amazon.
There is little to be learned from the gun people because the properties a functional (?) firearm (?) requires are super specific and don’t really correspond to much else.
To get a functional “good” diy fdm setup, you need to start with a ~$1000 printer like a prusa knockoff and build an enclosure with climate control around it and set up some kind of sbc that will manage all of that and maybe send commands to the printer to adjust its bullshit to whatever +/- 1 degree variation occurs.
Everything I just wrote is about fdm with non-basic pla stuff. If you just wanna make bowsette statues and guns then get whatever your files are sliced for (it’s an ender 3) and use that.
Resin printers can be more set and forget, but you need to buy a good one to start with, have ventilation, have wash and curing stations and it has to be able to handle whatever goofball non-warhammer-figurine material you’re using.
If you just want to print warhammer figurines then get an elegoo mars (?) and use it.
My goal is to be able to make little functional and decorative parts that look "good" without too terribly much post-processing. For example, I'd like to be able to print a case for the communist fantasy console project I'm working on and have the different parts actually line up instead of being all warped. Little functional parts for fixing things around the house, or printing decorations or prosthetics (Canadian healthcare basically only covers them in BC, so a lot of people never even have the chance to get one.) idk about printing a gun, especially as far as legality goes, but it sounds like that's on the "easier" side of FDM manufacturing from what you say
Okay, when you said you wanted to print parts I assumed you meant components with nylon or rubber attributes or something like that that needed to be more performant than pla.
If it’s just “stuff” you want to print but don’t want it to turn out all “fucked up” then get an ender and a cardboard box and some insulation and put the insulation on the inside of the box surfaces and put the box over the ender.
You won’t be able to see what’s happening, but after you calibrate the printer for use with an insulated enclosure (a cardboard box with old insulation stapled to it) it’ll be able to consistently crank out quality parts.
When you start getting self conscious about your trailer park ass 3d printer, look up some of the nicer clear plastic enclosure builds and make one of those.