15
klipper and octoeverywhere error... sort of?
(lemmy.nz)
So, mainly just a writing a PSA for any fellow printers out there using klipper with the octoeverywhere service. Updated both of my pi's yesterday that run two printers. Tried to access both through octoverywhere today and neither would connect.
Had to ssh into each unit and run 'bash <(curl -s https://octoeverywhere.com/install.sh)'
But as soon as each installer completed the connection was re-established and working.
The updated version of octoeverywhere that seemed to cause this is version 2.7.33-0-g4cb12230.
Just letting you guys know in case you run into this issue.
Hey man, your first layer isn't getting enough squish by the looks of it. It likes a decent amount of push into the bed compared to some other materials. PETG doesn't like as mush mash down as PLA. So if your printing PLA, try increasing your squish. You can do this via your z offset.
But do you really need your bed at 70? Mine runs and sticks just great at 60. 70 seems a bit warm for pla, as it keeps it just a bit too close to the glass transition temp for my liking. But if 70 has worked for you, then stay there.
But as another suggested, maybe raise your first layer temp by 5 or 10 and see if that helps. It might be that it needs a bit higher temp to flow better.