I might have crossed my wires, it was probably just a forum post I misread. I happened to have new ceramic burrs so I went ahead and installed them.
I got closer to a perfect pull this morning after adjusting the right lever! Unfortunately I'm out of that coffee now so the process restarts with the next bag.
New ceramic burrs.
I typically use light roast beans, apparently ceramic is better there.
Went through the hyperalignment procedure and got close but not perfect. Had to move on and get it back together at some point.
Works the same, just inline. And this grinder has two
Me writing my resume in third person
A blessing! Free credit monitoring! All is well
Free solo*
But with a harness full of gear for extra weight reasons
And gloves because less grip == good?
Me, spending hours on Age of Empires 2 and loving it
Janice from The Sopranos
True with crimps, not as important with pinches, which is what this mug is
This is how I did it with my old board. My new board has a jumper to toggle between powering via USB and not.
When the only tool you have is a deep lifelong understanding of computational language, everything starts to look like a hypergraph.
I don't know why I even bother opening the settings app
Designed this storage solution for belts
https://www.printables.com/model/519768-belt-organizer-hanger-6-or-8-belts
Had minimal clearance between these overhead shelves and the garage door, and the perfect light spacing was a few inches away from the cross bars. So I designed these snap fit brackets to offset the lights inline.
The lights make a huge difference, much more pleasant to work in the garage.
What I learned:
Also printed cable management clips
Made entirely from 1x2 pine. Ripped into thirds for the shelf slats. Pocket holes. Glue. Brads and glue for the shelf slats.
Is there a bad taxidermy community?